Subaru Legacy BN/BS (2015-2019) Service Manual: Real-time diagnosis operation
1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Engine Control System» and then «Enter». 5. On «Select Function» display, select «Data Monitor». 6. Make sure that normal display is shown when operated as follows: • Depress and release the brake pedal. (Stop light switch and brake switch are turned ON.) • Turn the “CRUISE” switch to ON. • Turn the “CANCEL” switch to ON. • Turn the “SET/−” switch to ON. • Turn the “RES/+” switch to ON. • Depress or release the clutch switch. • Place the shift lever in any position other than neutral. NOTE: For detailed operation procedures, refer to “Application help”. |
Read cancel code operation
1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. ...
Subaru select monitor operation
1. GENERAL DESCRIPTIONThe on-board diagnosis function of the cruise control system uses Subaru Select Monitor.The on-board diagnosis function operates in two categories, which are used depending on th ...
Other materials:
Procedure
1. PREPARATION FOR LEARNING1. Warm up or cool down until the ATF temperature displayed on the Subaru Select Monitor is 40 — 65°C (104 — 149°F).2. After stopping the vehicle, shift the select lever to “P” range.3. Apply the electronic parking brake.4. Lift up the vehicle ...
