Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Clutch system / Master cylinder / Removal

CAUTION:

• Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION

1. Turn the ignition switch to OFF.

2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE

3. Drain the brake fluid. Clutch Fluid

4. Remove the instrument panel lower cover. Instrument Panel Lower Cover > REMOVAL

5. Remove the steering column. Steering Column > REMOVAL

6. Remove the pedal assembly. Clutch Pedal > REMOVAL

7. Remove the clip and clevis pin, and then remove the push rod of the master cylinder.

(A)	Clevis pin
(B)	Clip
(C)	Push rod

8. Disconnect the clutch stroke sensor connector.

9. Remove the clutch pipe from the master cylinder.

10. Remove the master cylinder from the pedal bracket.

(A)	Master cylinder

Inspection

If any damage, deformation, wear, swelling, rust or other faults are found on the master cylinder assembly, reservoir tank, clutch damper, clutch pipe and clutch hose, replace the faulty part. ...

Other materials:

Axle boots & joints inspection
1. FRONT AND REAR AXLE BOOTSInspect the front axle boots (A) and rear axle boots (B) for deformation, damage or failure. If faulty, replace with new part. Front Drive Shaft Rear Drive Shaft• Front• Rear2. PROPELLER SHAFTInspect the propeller shaft for damage or failure. If faulty, repl ...