Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
CAUTION: • Be sure to prevent water or oil from contacting the connector terminal of front wheel speed sensor. If adhesion occurs, replace with a new part. • When removing front wheel speed sensor, CVTF may let out. If CVTF has leaked, adjust the CVTF level after installing the front wheel speed sensor. 1. Disconnect the ground terminal from battery sensor. NOTE 2. Lift up the vehicle. 3. Clean the transmission exterior. 4. Remove the front wheel speed sensor harness connector. 5. Remove the front wheel speed sensor.
|
Inspection
1. Remove the bulkhead harness connector from TCM. Transmission Control Module (TCM) > REMOVAL2. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD3. Set the probe of oscillo ...
Other materials:
Installation
CAUTION:• Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a).• Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the ...
