Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE NOTE: For CVT models, set the select lever to the “N” position before disconnecting the battery. 2. Remove the cover assembly - front. Console Box > REMOVAL 3. Remove the screws to remove the switch assembly - electronic parking brake.
|
Inspection
1. SWITCH ASSY - ELECTRONIC PARKING BRAKECheck the resistance between connector terminals.Switch positionTerminal No.StandardPress(Release)6 and 26 and 5Less than 1 -Neutral6 and 12 and 5Less than 1 - ...
Other materials:
Installation
CAUTION:Make sure that there is a gasket attached on the clip of the garnish assembly. If a gasket is not attached, water leakage may occur.1. Install the garnish assembly - rear gate.Tightening torque:4.5 N·m (0.5 kgf-m, 3.3 ft-lb)2. Install the cover - rear gate.Tightening torque:1.5 N&midd ...
© 2017-2025 Copyright www.sulegacy.com
