Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Memory height switch / Removal

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL

3. Release the claws and remove the memory height switch.

(c)	Model with SRF
(d)	Model without SRF

1. Measure the resistance between switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 4Switch OFF1 M- or moreSwitch ONLess than 1 -2. Apply battery voltage b ...

Other materials:

Inspection
1. Park the vehicle at a level place where there are enough area at the rear of the vehicle.2. Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.NOTE:Standard tape width is about 30 — 50 mm (1.18 — 1.97 in) and brilliant color shal ...