Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Rear suspension / Rear stabilizer / Removal

1. Lift up the vehicle, and then remove the rear wheels.

2. Remove the rear stabilizer.

(1) Remove the nut and disconnect the right and left stabilizer link assemblies.

(2) Detach the right and left clamps - stabilizer bushing and remove the rear stabilizer.

Installation

CAUTION:• For parts which are not reusable, always use new parts.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the g ...

Other materials:

Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides the driver with a warning message by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low. The tire pressure monitoring system will activate only when the vehicle is driven. Also, this system may not rea ...