Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.
3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron.
4. Disconnect the connector (A) from the starter, and remove the terminal (B).
5. Remove the bolts or nuts securing the starter, and remove the starter from the transmission. NOTE: For the MT model, a bolt is used at (a).
|
Starter
...
Assembly
1. Apply grease to the shaft sliding surfaces of the internal gear assembly.Grease:Multemp #6129 or equivalent2. Assemble the shaft to the internal gear assembly.3. Assemble the overrunning clutch as ...
Other materials:
Installation
CAUTION:• Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a).• Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the ...
