Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trim panel - rear pillar UPR. Rear Quarter Trim > REMOVAL 3. Remove the glass - rear quarter in the same procedure as for the glass - front window. Windshield Glass > REMOVAL |
Installation
1. Fabricate the cartridge nozzle tip as shown and set the sealant gun with the adhesive.(a)10 mm (0.39 in)(b)8 mm (0.31 in)(c)Sealant gun2. Smoothen and clean the adhesive surfaces of the glass - rea ...
Other materials:
Dtc p0032 a/f / o2 heater control circuit high bank 1 sensor 1
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...
© 2017-2025 Copyright www.sulegacy.com
