1. Clean the broken portion with alcohol or appropriate cleaning solvent. 2. Mask both side of wire with masking tape. 3. Apply the conductive silver composition to the broken portion. Conductive silver composition: Permatex QUICK GRID
4. Dry using a dryer after applying the composition. 5. After repair, check the wire. |
InspectionDtc p2401 evap system leak detection pump control circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE EZ (WITHOUT PUSH BUTTON ST ...