Subaru Legacy BN/BS (2015-2019) Service Manual: Transmission gear oil

Installation

1. Wipe off grease, oil and dust on the mating surfaces of transmission cases with cleaning solvent.2. Install the shifter fork and rod. Shifter Fork and Rod > INSTALLATION3. Install the reverse idle ...

Replacement

1. Pull out the oil level gauge.2. Lift up the vehicle.3. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.CAUTION:• Immediately after the vehicle ...

Other materials:

Dtc p2270 o2 sensor signal biased/stuck lean bank 1 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...