Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly
1. RADIATOR MAIN FAN AND RADIATOR MAIN FAN MOTOR 1. Install the radiator main fan motor to the radiator fan shroud. Tightening torque: 3.9 N·m (0.4 kgf-m, 2.9 ft-lb) 2. Install the radiator main fan to the radiator main fan motor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 3. Install the clip securing the connector of the radiator main fan motor to the radiator fan shroud. 2. RADIATOR SUB FAN AND RADIATOR SUB FAN MOTOR 1. Install the radiator sub fan motor to the radiator fan shroud. Tightening torque: 3.9 N·m (0.4 kgf-m, 2.9 ft-lb) 2. Install the radiator sub fan to the radiator sub fan motor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 3. Install the clip securing the connector of the radiator sub fan motor to the radiator fan shroud. 3. RADIATOR FAN SHROUD 1. Install the radiator main fan and the radiator main fan motor. Radiator Fan and Fan Motor Assembly > ASSEMBLY 2. Install the radiator sub fan and the radiator sub fan motor. Radiator Fan and Fan Motor Assembly > ASSEMBLY |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Drain approximately 3.0 L (3.2 US qt, 2.6 Imp qt) of coolant. Engine Coolant > REPLACEMENT3. Lower the vehicle.4. Remove the air intake ...
Installation
1. Position the radiator fan & fan motor assembly, and install the radiator fan & fan motor assembly to the claw on the radiator upper side.2. Connect the connector to the radiator main fan motor, as ...
Other materials:
Installation
NOTE:• Use a new gasket.• Be sure to install the clutch hose with the mark side facing upward.• Be careful not to twist the clutch hose during installation.• Before installing the operating cylinder, apply grease to the contact point of the release lever and operating cylinde ...
