Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Cooling(h4do) / Radiator fan and fan motor assembly / Installation

1. Position the radiator fan & fan motor assembly, and install the radiator fan & fan motor assembly to the claw on the radiator upper side.

2. Connect the connector to the radiator main fan motor, as well as the connector to the radiator sub fan motor.

3. Install the reservoir tank. Reservoir Tank > INSTALLATION

4. Connect the radiator inlet hose to the radiator.

5. Install the air intake duct. Air Intake Duct > INSTALLATION

6. Lift up the vehicle.

7. Install the under cover. Front Under Cover > INSTALLATION

8. Lower the vehicle.

9. Connect the ground terminal to battery sensor. NOTE

10. Fill engine coolant. Engine Coolant > REPLACEMENT

Assembly

1. RADIATOR MAIN FAN AND RADIATOR MAIN FAN MOTOR1. Install the radiator main fan motor to the radiator fan shroud.Tightening torque:3.9 N·m (0.4 kgf-m, 2.9 ft-lb)2. Install the radiator main fa ...

Inspection

Check that the radiator fan, radiator fan shroud and fan motor do not have deformation, cracks or damage. ...

Other materials:

Dtc b1820 short in side airbag rh
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Shorted between +/− lines (shorted between main harness lines, shorted between front seat side airbag RH lines, shorted between airbag CM internal lines)CAUTION:Before performing diagnosis, refer to “CAUTI ...