Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly
1. RADIATOR MAIN FAN AND RADIATOR MAIN FAN MOTOR 1. Install the radiator main fan motor to the radiator fan shroud. Tightening torque: 3.9 N·m (0.4 kgf-m, 2.9 ft-lb) 2. Install the radiator main fan to the radiator main fan motor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 3. Connect the connector to the radiator fan control module (main), and install the radiator main fan motor harness. 2. RADIATOR SUB FAN AND SUB FAN MOTOR 1. Install the radiator sub fan motor to the radiator fan shroud. Tightening torque: 3.9 N·m (0.4 kgf-m, 2.9 ft-lb) 2. Install the radiator sub fan to the radiator sub fan motor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 3. Connect the connector to the radiator fan control module (sub), and install the radiator sub fan motor harness. 3. RADIATOR FAN HARNESS Set the radiator fan harness to the radiator fan shroud, and install the clip securing radiator fan harness.
4. RADIATOR FAN SHROUD 1. Install the radiator main fan and the radiator main fan motor. Radiator Fan and Fan Motor Assembly > ASSEMBLY 2. Install the radiator sub fan and the radiator sub fan motor. Radiator Fan and Fan Motor Assembly > ASSEMBLY 3. Install the radiator fan harness. Radiator Fan and Fan Motor Assembly > ASSEMBLY 4. Install the radiator fan control module. Radiator Fan Control Unit > INSTALLATION |
Removal
1. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the front of collector cover at two positions (B) while moving it forward.2. ...
Installation
1. Position the radiator fan & fan motor assembly, and install the radiator fan & fan motor assembly to the claw on the radiator upper side.2. Connect radiator inlet hoses LH and RH to the radiator.3. ...
Other materials:
Dtc p0112 intake air temperature sensor 1 circuit low bank 1
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM: ...
