Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly

Subaru Legacy BN/BS (2015-2019) Service Manual / Drive shaft system / Front hub unit bearing / Assembly

1. Install the hub unit COMPL to the ST securely.

Preparation tool:

ST: HUB STAND (28099PA080)

2. Using a press, press new bolts - hub until their seating surfaces contact the hub unit COMPL.

NOTE:

Use the 12 mm (0.47 in) dia. holes in the HUB STAND to prevent bolts from tilting.

(1)	Hub unit COMPL - front axle

Removal

1. Lift up the vehicle, and then remove the front wheels.2. Remove the nut - axle.CAUTION:Do not loosen the nut - axle while the front axle is loaded. Doing so may damage the hub unit COMPL.(1) Lift t ...

Installation

1. Tighten the back plate - front brake and the hub unit COMPL - front axle to the housing assembly - front axle with bolts.CAUTION:• Do not get closer the tool which charged magnetism to magnet ...

Other materials:

Installation
1. SEDAN MODEL1. Install the light assembly - high-mounted.2. Install the trim panel assembly - rear shelf. Rear Shelf Trim > INSTALLATION3. Connect the ground terminal to battery sensor. NOTE2. OUTBACK MODELCAUTION:Make sure the bolt is tightened securely because improper roof spoiler installatio ...