Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly
CAUTION: Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb. 1. HIGH BEAM BULB 1. Install the high beam bulb. 2. Connect the connector. 2. LOW BEAM BULB (HALOGEN TYPE) 1. Install the low beam bulb. 2. Connect the connector. 3. LOW BEAM BULB (HID TYPE) 1. Install the low beam bulb. 2. Install the ballast - headlight. 4. SIDE MARKER LIGHT BULB 1. Install the side marker light bulb. 2. Install the bulb socket. 5. TURN SIGNAL LIGHT BULB 1. Install the turn signal light bulb. 2. Install the bulb socket. |
Disassembly
CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.1. HIGH BEAM BULB1. Disconnect the connector.2. Rotate in the direction of arrow shown in the figure t ...
Headlight bulb
...
Other materials:
Engine coolant
Checking the coolant level
1) "FULL" level mark
2) "LOW" level mark
Check the coolant level at each fuel stop.
Check the coolant level on the outside
of the reservoir while the engine is cool.
If the level is close to or lower than the
"LOW" level mark, add coolant up to ...
