Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Rear combination light assembly / Inspection

1. Apply battery voltage between the connector terminals to check the lighting condition of the light.

• Sedan model

Terminal No.	Inspection conditions	Specification
3 (+) — 2 (−)	Apply battery voltage.	Stop light on
4 (+) — 2 (−)		Tail / side marker light on
1 (+) — 2 (−)		Turn signal light on

• OUTBACK model

Terminal No.	Inspection conditions	Specification
4 (+) — 3 (−)	Apply battery voltage.	Stop light on
2 (+) — 3 (−)		Tail / side marker light on
1 (+) — 3 (−)		Turn signal light on

2. Replace the harness and bulb if it is found defective.

Installation

1. SEDAN MODEL1. Replace the light assembly gasket with a new part.2. Install the light assembly - rear combination.CAUTION:Be careful not to catch the harness in between the parts.Tightening torque:4 ...

Disassembly

CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.1. TAIL LIGHT/STOP LIGHT BULBNOTE:Since the LED type is a non-disassembled part, it cannot be removed. ...

Other materials:

Installation
CAUTION:• Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a).• Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the ...