Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Rear combination light assembly / Installation

1. SEDAN MODEL

1. Replace the light assembly gasket with a new part.

2. Install the light assembly - rear combination.

CAUTION:

Be careful not to catch the harness in between the parts.

Tightening torque:

4.5 N·m (0.5 kgf-m, 3.3 ft-lb)

3. Install the trunk trim panel - side.

4. Connect the ground terminal to battery sensor. NOTE

2. OUTBACK MODEL

1. Install the light assembly - rear combination.

CAUTION:

Be careful not to catch the harness in between the parts.

Tightening torque:

7.5 N·m (8.0 kgf-m, 5.5 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

Assembly

CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.1. TURN SIGNAL LIGHT BULB1. Install the turn signal light bulb.2. Install the bulb socket.2. SIDE MARK ...

Inspection

1. Apply battery voltage between the connector terminals to check the lighting condition of the light.• Sedan modelTerminal No.Inspection conditionsSpecification3 (+) — 2 (−)Apply batter ...

Other materials:

Installation
1. WASHER TANKCAUTION:• Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).• Before installing the bumper face, match the claws on the bracket - front bumper with ...