Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Rear combination light assembly / Assembly

CAUTION:

Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.

1. TURN SIGNAL LIGHT BULB

1. Install the turn signal light bulb.

2. Install the bulb socket.

2. SIDE MARKER LIGHT BULB

1. Install the side marker light bulb.

2. Install the bulb socket.

Removal

1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel - side. Trunk Room Trim > REMOVAL3. Remove the light assembly - rear combination.(1) Remove th ...

Installation

1. SEDAN MODEL1. Replace the light assembly gasket with a new part.2. Install the light assembly - rear combination.CAUTION:Be careful not to catch the harness in between the parts.Tightening torque:4 ...

Other materials:

Dtc p0117 engine coolant temperature sensor 1 circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Hard to start• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROC ...