Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. SEDAN MODEL 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trunk trim panel - side. Trunk Room Trim > REMOVAL 3. Remove the light assembly - rear combination. (1) Remove the harness clip and connector. (2) Release the nuts and clips, then remove the light assembly - rear combination. CAUTION: Be careful not to damage the clips.
2. OUTBACK MODEL 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the light assembly - rear combination. (1) Remove the clips and detach the rear combination light covers. (2) Remove the bolt and release the clip. (3) Disconnect the connector and remove the light assembly - rear combination. CAUTION: Be careful not to damage the clips.
|
Assembly
CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.1. TURN SIGNAL LIGHT BULB1. Install the turn signal light bulb.2. Install the bulb socket.2. SIDE MARK ...
Other materials:
Replacing bulbs
WARNING
Bulbs may become very hot while
illuminated. Before replacing bulbs,
turn off the lights and wait until the
bulbs cool down, Otherwise, there is
the risk of sustaining a burn injury.
CAUTION
Replace any bulb only with a new
bulb of the specifi ...
