Subaru Legacy BN/BS (2015-2019) Service Manual: Auto headlight beam leveler control module

Tail stop light bulb note

Since the tail light / stop light bulb (LED) is a non-disassembled part, it cannot be removed from the rear combination light assembly. ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Remove the bolts, and then remove the ...

Other materials:

Installation
1. Install the starter to the transmission.NOTE:Tighten the starter and bracket (a) together using the upper bolt securing the starter.Tightening torque:50 N·m (5.1 kgf-m, 36.9 ft-lb)2. Connect the connector (A) to the starter, and install the terminal (B).Tightening torque:10 N·m (1.0 ...