Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Auto headlight beam leveler control module / Installation

1. Install the auto headlight beam leveler CM.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

2. Install the relay holder.

3. Install the panel - knee guard.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

4. Install the cover assembly - instrument panel LWR driver.

5. Connect the ground terminal to battery sensor. NOTE

6. Perform initialization and reinitialization of the auto headlight beam leveler system. Auto Headlight Beam Leveler System > PROCEDURE

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Remove the bolts, and then remove the ...

Auto headlight beam leveler system

...

Other materials:

Installation
1. Before installation, check the following items.• Cable and rod are free from deformation.• Grease is applied sufficiently to rod joints.If grease is insufficient, add it as necessary before assembling the rod.2. Install the latch and actuator assembly - front.CAUTION:Do not re-use the ...