Subaru Legacy BN/BS (2015-2019) Service Manual: Clear active lane keep system learning value operation
1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «EyeSight» and select «Enter». 5. On «Select Function» display, select «Work Support». 6. On «Work Support» display, select «Clear Active Lane Keep System Learning Value». NOTE: • When suspension parts are replaced or wheel alignment is adjusted, perform «Clear Active Lane Keep System Learning Value». • For detailed operation procedures, refer to “Application help”. |
Check list for interview check
Inspect the following items regarding the vehicle’s state.Writer/InspectorWriter’s name Inspector’s Name Vehicle informationCar accessory equipment conditionCar accessory is installe ...
Clear memory mode operation
1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. ...
Other materials:
Dtc p0030 a/f / o2 heater control circuit bank 1 sensor 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...
