Subaru Legacy BN/BS (2015-2019) Service Manual: Disassembly

Subaru Legacy BN/BS (2015-2019) Service Manual / Exterior interior trim / Rear gate garnish / Disassembly

1. Remove the protector UPR. Rear Gate Garnish > REPLACEMENT

2. Remove the button - opener rear gate. Rear Gate Opener Button > REMOVAL

3. Remove the garnish LWR as required.

Installation

CAUTION:Make sure that there is a gasket attached on the clip of the garnish assembly. If a gasket is not attached, water leakage may occur.1. Install the garnish assembly - rear gate.Tightening torqu ...

Rear gate trim

...

Other materials:

Inspection
1. CRANKSHAFT POSITION SENSOR1. Disconnect the ground terminal from battery sensor. NOTE2. Prepare an oscilloscope.3. While pressing the section (A) shown in the figure, move the lock lever (B) in the direction of the arrow to disconnect the connectors from the ECM in numerical order as shown in th ...