Subaru Legacy BN/BS (2015-2019) Service Manual: Exterior interior trim
Subaru Legacy BN/BS (2015-2019) Service Manual / Exterior interior trim
- Fuel tank protector note
- General description preparation tool
- Heat shield cover note
- Ornament installation
- Assist grip
- Center console
- Console box
- Cowl panel
- Door trim
- Floor mat
- Floor under protector
- Front bumper
- Front grille
- Front under cover
- Glove box
- Instrument panel assembly
- Instrument panel lower cover
- Lower inner trim
- Mud guard
- Rear bumper
- Rear gate garnish
- Rear gate trim
- Rear quarter trim
- Rear shelf trim
- Roof molding
- Roof rail
- Roof spoiler
- Roof trim
- Side garnish
- Sun visor
- Trunk lid garnish
- Trunk room trim
- Upper inner trim
Installation
1. Install the hinge assembly - trunk lid.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)2. Install the trunk lid COMPL.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)3. Install the st ...
Fuel tank protector note
Refer to “FUEL INJECTION” section for removal and installation procedure of the fuel tank protector.• H4 model: Fuel Tank Protector > REMOVAL• H6 model: Fuel Tank Protector > ...
Other materials:
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the heater control assembly.(1) Release the clips and claws, then detach the control module cover.(2) Release the screws and clips, then detach the heater control assembly.CAUTION:• Insert a flat tip screwdriver wrapped with ...
© 2017-2025 Copyright www.sulegacy.com
