CAUTION: Make sure that there is a gasket attached on the clip of the garnish assembly. If a gasket is not attached, water leakage may occur. 1. Install the garnish - trunk. Tightening torque: 4.5 N·m (0.5 kgf-m, 3.3 ft-lb) 2. Install the trim panel - trunk lid. 3. Connect the ground terminal to battery sensor. NOTE |
Removal
Trunk room trimDtc p014e a/f / o2 sensor slow response - rich to lean bank 2 sensor 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.STEPCHECKYESNO1.CHECK EXHAUST SYSTEM.NOTE:Check the foll ...