Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: For installation of the rod - power rear gate, refer to “INSTALLATION”, “Power Rear Gate Rod” in the “POWER REAR GATE” section and observe the precautions for installation. Power Rear Gate Rod > INSTALLATION 1. Install the trim panel - rear gate LWR. (1) Install the power rear gate inner switch. (2) Install the hand grip. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the trim panel - rear gate pillar side. 3. Install the trim panel - rear gate pillar UPR. |
Removal
1. Remove the trim panel - rear gate UPR.(1) Remove the claws on the trim edge.(2) Release the claws in the center of trim, and remove the trim panel - rear gate UPR.2. Remove the trim panel - rear ga ...
Other materials:
Installation
1. Temporarily install the drive plate and reinforcement drive plate.NOTE:Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.2. Set the ST.NOTE:Set the ST to the drive plate referring to the illustration.ST 498497300CRANKSHA ...
