Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the hinge assembly - trunk lid. Tightening torque: 25 N·m (2.5 kgf-m, 18.4 ft-lb) 2. Install the trunk lid COMPL. Tightening torque: 25 N·m (2.5 kgf-m, 18.4 ft-lb) 3. Install the stopper - trunk lid LWR. 4. Adjust while paying attention to make a uniform clearance around the trunk lid COMPL. Trunk Lid > ADJUSTMENT 5. Install the stay assembly - trunk lid. Tightening torque: Refer to “COMPONENT” of “General Description”. General Description > COMPONENT 6. Install the stopper - hinge. 7. Install the harness clip and the harness. 8. Install the light assembly - rear finisher. Rear Finisher Light Assembly > INSTALLATION Tightening torque: 4.5 N·m (0.5 kgf-m, 3.3 ft-lb) 9. Install the license plate light. License Plate Light > INSTALLATION 10. Install the key lock - trunk lid. 11. Install the rearview camera assembly. Rearview Camera System > INSTALLATION 12. Install the garnish - trunk. Trunk Lid Garnish > INSTALLATION Tightening torque: 4.5 N·m (0.5 kgf-m, 3.3 ft-lb) 13. Install the rear antenna assembly - exterior. 14. Install the lock assembly - trunk lid. Tightening torque 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 15. Install the trim panel - trunk lid. Trunk Room Trim > INSTALLATION 16. Connect the ground terminal to battery sensor. NOTE |
Adjustment
Adjust the clearance around the trunk lid COMPL as follows.PartStandardATrunk lid COMPL and Panel - side outer3.5±1.0 mm (0.14±0.04 in)BSurface level gap between Trunk lid COMPL and Panel - side out ...
Other materials:
Inspection
1. Check the chain cover surface for scratches or dents.2. Check for oil leakage on the chain cover mating surface and installation part of crank pulley.If there is an oil leak from the oil seal, perform replacement with a new oil seal.ST 499585700OIL SEAL GUIDEOil seal press-fit position:− ...
