Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: Make sure that there is a gasket attached on the clip of the garnish assembly. If a gasket is not attached, water leakage may occur. 1. Install the garnish assembly - rear gate. Tightening torque: 4.5 N·m (0.5 kgf-m, 3.3 ft-lb) 2. Install the cover - rear gate. Tightening torque: 1.5 N·m (0.2 kgf-m, 1.1 ft-lb) 3. Install the power rear gate touch sensor LWR. (Model with power rear gate) Power Rear Gate Touch Sensor > INSTALLATION 4. Install the rear gate trim. 5. Connect the ground terminal to battery sensor. NOTE |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the rear gate trim. Rear Gate Trim > REMOVAL3. Remove the garnish assembly - rear gate.(1) Remove the bolts and clips, and remove ...
Disassembly
1. Remove the protector UPR. Rear Gate Garnish > REPLACEMENT2. Remove the button - opener rear gate. Rear Gate Opener Button > REMOVAL3. Remove the garnish LWR as required. ...
Other materials:
Dtc p2007 tgv control stuck closed bank 2
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.STEPCHECKYESNO1.CHECK FOR ANY OTHER DTC ON DISPLAY.Is any other DTC displayed-Check th ...
