Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Make sure that packings are attached on the clips of the roof spoiler assembly. If a gasket is not attached, water leakage may occur. • Connect the connector of the light assembly - high-mounted securely. 1. Install the roof spoiler. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the drip - rear gate. (Except for model with power rear gate) 3. Install the trim panel - rear gate UPR and the trim panel - rear gate pillar side. Rear Gate Trim > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear gate UPR and the trim panel - rear gate pillar side. Rear Gate Trim > REMOVAL3. Remove the drip - rear gate ...
Roof trim
...
Other materials:
Dtc p2197 a/f / o2 sensor signal biased/stuck lean bank 2 sensor 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...
