Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Exterior interior trim / Assist grip / Installation

1. Pinch the metal clip with pliers, and remove it from the assist grip BRKT.

2. Install the metal clip to the assist grip side.

3. Install the cap to the assist grip.

NOTE:

If the metal clip is not inserted to the end, the cap cannot be installed.

4. Install the assist grip to the vehicle.

Removal

1. Pull up the cap (b) while pulling the knob (a) toward you with a flat tip screwdriver or similar tool wrapped with a protection tape.2. Pull the assist grip toward yourself (toward the vehicle cent ...

Center console

...

Other materials:

Installation
1. Install the knock sensor to the cylinder block, and connect the connector (A) to the knock sensor.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)NOTE:The knock sensor should be installed so that the center of the connector is positioned as shown in the figure relative to the front of engi ...