Honda Civic manuals

Subaru Legacy Service Manual: Disassembly

1. Using a coil spring compressor, compress the coil spring.

2. Using a hexagon wrench to prevent the shock absorber piston rod from turning, remove the self-locking nut with ST.

CAUTION:

When installing the coil spring compressor to the coil spring, follow the operation manual accompanied with the coil spring compressor during operation.

Preparation tool:

ST: STRUT MOUNT SOCKET (20399FG000)

NOTE:

The installing position of coil spring compressor varies depending on the coil spring shape and winding number.

3. Remove the rubber seat - shock UPR and shock mount - rear from the shock absorber COMPL - rear.

4. Gradually decrease the compression pressure of compressor, and remove the coil spring - rear.

5. Remove the helper - rear and the dust cover - rear shock.

Disposal
CAUTION:• Before handling the shock absorber, be sure to wear goggles to protect eyes from gas, oil and cutting powder.• Do not disassemble the shock absorber or place it into a fire.&bull ...

Rear stabilizer
...

Other materials:

Dtc b16a7 short in front sub sensor lh (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Shorted between front sub sensor LH circuit and GND circuitWIRING DIAGRAM:NOTE:For the coupling connector, refer to “WIRING SYSTEM”.Airbag system Airbag System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK POOR C ...

© 2017-2022 Copyright www.sulegacy.com