Subaru Legacy BN/BS (2015-2019) Owners Manual: Door unlock selection function

Subaru Legacy BN/BS (2015-2019) Owners Manual / Keys and doors / Keyless access with push-button start system (if equipped) / Locking and unlocking with "keyless access" entry function / Door unlock selection function

The door unlock selection function makes the following operations possible.

Unlocking the driver's door without unlocking any other doors (including the rear gate) when gripping the driver's door handle
For Outback, opening the rear gate without unlocking any doors when pressing the rear gate opener button

The operational/non-operational setting for this function can be changed by operating the multi information display.

For details, refer to "Keyless Entry System" . The setting can also be changed by a SUBARU dealer. Consult your SUBARU dealer for details.

Operational:

Only the driver's door will be unlocked when the driver's door handle is gripped.
For Outback, the rear gate will open, but the other doors will remain locked when the rear gate opener button is pressed.

Non-operational:

All doors and the rear gate will be unlocked when the driver's door handle is gripped.
For Outback, the rear gate will open and all doors will be unlocked when the rear gate opener button is pressed.
The factory setting (default setting) is set as "operational".

Power saving function

To protect the access key battery and the vehicle battery, the keyless access function will be disabled as follows. When the keyless access function and the remote keyless entry system h ...

Selecting audible signal operation

Using an electronic chirp, the system will give you an audible signal when the doors are locked or unlocked. If desired, you can turn the audible signal off by operating the multi information disp ...

Other materials:

Dtc c1721 yaw rate sensor
DTC DETECTING CONDITION:• A fault is detected if the sensor signal value is not correct.• A fault is detected if the steering angle sensor signal / lateral G sensor signal change while the yaw rate sensor signal indicates a constant value.• A fault is detected if the communication ...