Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b1408 meter non-volatile memory

Subaru Legacy BN/BS (2015-2019) Service Manual / Immobilizer (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b1408 meter non-volatile memory

DIAGNOSIS START CONDITION:

• Battery voltage is 10 V or more.

• The remote engine starter was not used to start the engine.

DTC DETECTING CONDITION:

Defective combination meter

TROUBLE SYMPTOM:

• Engine will not start.

• The security indicator illuminates.

CAUTION:

When the combination meter is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

STEP	CHECK	YES	NO
1.CHECK COMBINATION METER REGISTRATION. 1) Perform the Clear Memory Mode. (Combination meter and body integrated unit) Clear Memory Mode Clear Memory Mode 2) Perform registration of combination meter. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume. 3) Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)	Is DTC B1408 displayed-	Replace the combination meter. Combination Meter	Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Dtc b1410 transponder communication

NOTE:Refer to DTC B1574 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1574 KEY COMMUNICATION ...

Dtc b1407 met communication

DIAGNOSIS START CONDITION:• Battery voltage is 10 V or more.• The remote engine starter was not used to start the engine.DTC DETECTING CONDITION:Communication failure between body integrat ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron.4. Disconnect the connector (A ...