Subaru Legacy BN/BS (2015-2019) Service Manual: Immobilizer (diagnostics)
Subaru Legacy BN/BS (2015-2019) Service Manual / Immobilizer (diagnostics)
- Basic diagnostic procedure procedure
- Clear memory mode operation
- Diagnostics chart for security indicator light inspection
- Electrical component location location
- Immobilizer control module i o signal wiring diagram
- Inspection mode procedure
- List of diagnostic trouble code (dtc) list
- Read diagnostic trouble code (dtc) operation
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc b1571 reference code incompatibility (immobilizer cm to ecm)
- Dtc b1401 meter collation
- Dtc b1414 immobilizer control module non-volatile memory
- Dtc b1413 immobilizer control module battery power supply
- Dtc b1412 immobilizer control module can register stuck
- Dtc b1578 meter
- Dtc b1577 imm control module eeprom
- Dtc b1576 egi control module eeprom
- Dtc b1575 incorrect immobilizer key
- Dtc b1574 key communication
- Dtc b1572 imm circuit except antenna circuit
- Dtc b1570 antenna
- Dtc b1411 immobilizer antenna
- Dtc b1410 transponder communication
- Dtc b1408 meter non-volatile memory
- Dtc b1407 met communication
- Dtc b1402 immobilizer key collation
- Freeze frame data display
- General description
- Read current data
- Subaru select monitor
Installation
1. Install the sunload sensor.2. Install the grille - front defroster.3. Install the grille speaker side.4. Install the trim panel - front pillar UPR. Upper Inner Trim > INSTALLATION5. Connect the gr ...
Basic diagnostic procedure procedure
1. WITHOUT KEYLESS ACCESS WITH PUSH BUTTON START SYSTEMCAUTION:When the body integrated unit (except for C0 and C5 models) or the immobilizer CM (C0 and C5 models) is replaced, registration of the imm ...
Other materials:
Removal
1. RADIO ANTENNA AMPLIFIER• Sedan model1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - rear pillar UPR LH. Rear Quarter Trim > REMOVAL3. Remove the amplifier assembly - antenna.(1) Disconnect the ...
© 2017-2026 Copyright www.sulegacy.com
