Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b1576 egi control module eeprom

Subaru Legacy BN/BS (2015-2019) Service Manual / Immobilizer (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b1576 egi control module eeprom

DIAGNOSIS START CONDITION:

• Battery voltage is 10 V or more.

• The remote engine starter was not used to start the engine.

DTC DETECTING CONDITION:

• ECM malfunctioning

• Failed to access ROM in ECM during key registration.

TROUBLE SYMPTOM:

• Engine will not start.

• The security indicator illuminates.

CAUTION:

When the ECM is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

STEP	CHECK	YES	NO
1.PERFORM ECM REGISTRATION. Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.	Is registration complete-	Finish the diagnosis.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1576 EGI CONTROL MODULE EEPROM
2.PERFORM ECM REGISTRATION. Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.	Is registration complete-	Finish the diagnosis.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1576 EGI CONTROL MODULE EEPROM
3.PERFORM ECM REGISTRATION. Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.	Is registration complete-	Finish the diagnosis.	Refer to “Correspondence table when registration is not possible” in the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume. If the registration still does not work properly, replace the ECM. Engine Control Module (ECM) Engine Control Module (ECM)

Dtc b1577 imm control module eeprom

DIAGNOSIS START CONDITION:• Battery voltage is 10 V or more.• The remote engine starter was not used to start the engine.DTC DETECTING CONDITION:• Defective body integrated unit (exc ...

Dtc b1575 incorrect immobilizer key

1. EXCEPT FOR C0 AND C5 MODELSDIAGNOSIS START CONDITION:• Battery voltage is 10 V or more.• The remote engine starter was not used to start the engine.DTC DETECTING CONDITION:Use of unregi ...

Other materials:

Installation
1. Clean the mating surface of extension case and transmission case.2. Select the transfer drive gear shim. Reduction Drive Gear > ADJUSTMENT3. Select the transfer driven gear shim. Transfer Clutch > ADJUSTMENT4. Attach the selected transfer drive gear shim to extension case with vaseline.5. Attac ...