Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b2a07 backup battery charge system performance

Subaru Legacy BN/BS (2015-2019) Service Manual / Telematics system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b2a07 backup battery charge system performance

DIAGNOSIS START CONDITION:

When ignition switch is ON.

DTC DETECTING CONDITION:

Backup battery is disconnected for at least 5 seconds when the ignition switch is turned ON. (Detached backup battery connection, etc.)

TROUBLE SYMPTOM:

• ACN/SOS function cannot be used when the main battery is disconnected.

• RED LED illuminates.

CAUTION:

CommCheck is required after replacing the DCM. Telematics System > OPERATION

STEP	CHECK	YES	NO
1.CHECK DTC. Read the DTC. Diagnostic Code(s) Display	Is DTC B2A07 displayed- (Current malfunction)	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A07 BACKUP BATTERY CHARGE SYSTEM PERFORMANCE	Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2.CHECK THE BACKUP BATTERY. 1) Remove the DCM. Data Communication Module 2) Remove the backup battery cover. 3) Disconnect the backup battery connector. 4) Measure the backup battery voltage.	Is the voltage 2.0 V or more-	Replace the DCM. Data Communication Module	Replace the backup battery. Data Communication Module

Dtc b2a10 battery voltage high

DIAGNOSIS START CONDITION:When ignition switch is ON.DTC DETECTING CONDITION:DCM battery power supply input of 16 V or more continues for 5 seconds.TROUBLE SYMPTOM:RED LED illuminates.CAUTION:CommChec ...

Dtc u0151 lost communication with restraints control module

Detected when CAN data is not received from airbag CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE ...

Other materials:

List of diagnostic trouble code (dtc) list
DTCItemNoteB2240CAN COMMUNICATION (AUDIO) STUCK Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2240 CAN COMMUNICATION (AUDIO) STUCKB2241CAN COMMUNICATION Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2241 CAN COMMUNICATIONB2242UART COMMUNICATION Diagnostic Procedure ...