Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b2a10 battery voltage high

Subaru Legacy BN/BS (2015-2019) Service Manual / Telematics system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b2a10 battery voltage high

DIAGNOSIS START CONDITION:

When ignition switch is ON.

DTC DETECTING CONDITION:

DCM battery power supply input of 16 V or more continues for 5 seconds.

TROUBLE SYMPTOM:

RED LED illuminates.

CAUTION:

CommCheck is required after replacing the DCM. Telematics System > OPERATION

STEP	CHECK	YES	NO
1.CHECK DTC. Read the DTC. Diagnostic Code(s) Display	Is DTC B2A10 displayed- (Current malfunction)	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A10 BATTERY VOLTAGE HIGH	Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2.CHECK CURRENT DATA. Check «Battery Voltage» in «Current Data Display & Save». Read Current Data	Is «Battery Voltage» OK-	Replace the DCM. Data Communication Module	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A10 BATTERY VOLTAGE HIGH
3.CHECK BATTERY. Check the battery unit. Battery > INSPECTION General Description > SPECIFICATION	Is the battery OK-	Replace the DCM. Data Communication Module	Replace the battery. Battery General Description

Dtc u0155 lost communication with instrument panel cluster (ipc) control module

Detected when CAN data from combination meter does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE ...

Dtc b2a07 backup battery charge system performance

DIAGNOSIS START CONDITION:When ignition switch is ON.DTC DETECTING CONDITION:Backup battery is disconnected for at least 5 seconds when the ignition switch is turned ON. (Detached backup battery conne ...

Other materials:

Removal
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL2. Remove the clutch release lever and the release bearing. Release Bearing and Lever > REMOVAL3. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case ...