Subaru Legacy BN/BS (2015-2019) Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
Subaru Legacy BN/BS (2015-2019) Service Manual / Telematics system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u1235 lost communication with eyesight
- Dtc u0100 lost communication with ecm/pcm "a"
- Dtc u0452 invalid data received from restraints control module
- Dtc u0073 control module communication bus off
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0402 invalid data received from tcm
- Dtc u0401 invalid data received from ecm/pcm "a"
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc b2a10 battery voltage high
- Dtc b2a07 backup battery charge system performance
- Dtc u0151 lost communication with restraints control module
- Dtc u0140 lost communication with body control module
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc b2a0f backup battery degradation
- Dtc b2a0e mute line circuit
- Dtc b2a0d airbag signal
- Dtc b2a0c dcm internal fault
- Dtc b2a0b green led circuit
- Dtc b2a0a red led circuit
- Dtc b2a09 i-call button circuit
- Dtc b2a08 sos button circuit
- Dtc b2a06 right speaker/audio circuit
- Dtc b2a05 left speaker/audio circuit
- Dtc b2a04 mic circuit
- Dtc b2a03 gps antenna circuit
- Dtc b2a02 lte2 antenna circuit
- Dtc b2a01 lte1 antenna circuit
- Dtc b2a00 vin reading
- Dtc u0074 control module communication bus "body-can" off
- Dtc u0101 lost communication with tcm
List
DTCItemNoteU0073CAN FAILURE, BUS ‘OFF’ DETECTION Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFU0074CONTROL MODULE COMMUNICATION B ...
Dtc u1235 lost communication with eyesight
Detected when CAN data from the stereo camera does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE ...
Other materials:
Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardBetween all terminals(A)LOCK1 M- or more2 — 4(B)ACCLess than 1 -1 — 2 — 45 — 6(C)ONLess than 1 -1 — 3 — 45 — 6 — 7(D)STLess than 1 -2. Replace the ignition sw ...
© 2017-2026 Copyright www.sulegacy.com
