Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc c2545 eyesight system

Subaru Legacy BN/BS (2015-2019) Service Manual / Power assisted system (power steering) (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc c2545 eyesight system

DTC DETECTING CONDITION:

When the EyeSight system fail flag from stereo camera is received after the ignition switch is ON.

TROUBLE SYMPTOM:

EyeSight steering support function does not operate.

STEP	CHECK	YES	NO
1.CHECK POOR CONTACT OF CONNECTOR.	Is there poor contact of the stereo camera connector-	Repair the poor contact of connector.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2545 EyeSight SYSTEM
2.CHECK DTC. Read the DTC for the EyeSight system using the Subaru Select Monitor.	Is DTC of EyeSight system detected-	Perform the diagnosis according to the DTC.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2545 EyeSight SYSTEM
3.CHECK LAN SYSTEM. Perform the diagnosis for LAN system using the Subaru Select Monitor. Basic Diagnostic Procedure	Is a DTC related to CAN communication detected-	Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2545 EyeSight SYSTEM
4.CHECK POWER STEERING CONTROL MODULE. 1) Connect all connectors. 2) Perform the Clear Memory Mode. Clear Memory Mode 3) Perform the Inspection Mode. Inspection Mode 4) Read the DTC.	Is DTC C2545 detected-	Replace the steering gearbox. Electric Power Steering Gearbox	It results from a temporary noise interference.

Dtc c2546 eyesight value

DTC DETECTING CONDITION:When the steering support indication value from stereo camera is out of range after the ignition switch is ON.TROUBLE SYMPTOM:EyeSight steering support function does not operat ...

Dtc c2544 auto start stop system

DTC DETECTING CONDITION:• When a failure of CAN communication is detected after the ignition switch is ON.• When the power steering control module has a detection error after the ignition ...

Other materials:

Dtc p0304 cylinder 4 misfire detected
DTC DETECTING CONDITION:• Detected when two consecutive driving cycles with fault occur.• Immediately at fault recognition (A misfire which could damage catalyst occurs.)TROUBLE SYMPTOM:• Engine stalls.• Improper idling• Rough drivingCAUTION:After servicing or replacing ...