Subaru Legacy BN/BS (2015-2019) Service Manual: Power assisted system (power steering) (diagnostics)
Subaru Legacy BN/BS (2015-2019) Service Manual / Power assisted system (power steering) (diagnostics)
- Basic diagnostic procedure procedure
- Check list for interview check
- Clear memory mode operation
- Electrical component location location
- Inspection mode procedure
- List of diagnostic trouble code (dtc) list
- Read diagnostic trouble code (dtc) operation
- Control module i o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u1469 invalid data received from autostart stop control module
- Dtc u0100 lost communication with ecm/pcm "a"
- Dtc u1433 invalid data received from eyesight
- Dtc u1235 lost communication with eyesight
- Dtc u1120 lost communication with autostart stop control module
- Dtc u0073 control module communication bus off
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0401 invalid data received from ecm/pcm "a"
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc c2551 power supply relay
- Dtc c2548 vehicle dynamics control module system
- Dtc c2547 eyesight check sum
- Dtc c2546 eyesight value
- Dtc c2545 eyesight system
- Dtc c2544 auto start stop system
- Dtc c2543 error passive
- Dtc c2541 vehicle dynamics control module vehicle speed sensor
- Dtc c2533 control module board temperature sensor
- Dtc c2532 control module peripheral circuit
- Dtc c2531 control module cpu
- Dtc c2522 resolver sensor
- Dtc c2521 motor malfunction
- Dtc c2514 torque sensor power supply
- Dtc c2513 torque sensor much tolerance
- Dtc c2512 torque sensor sub
- Dtc c2511 torque sensor main
- Dtc u0126 lost communication with steering angle sensor module
- Dtc u0122 lost communication with vehicle dynamics control module
- General description
- Steering warning light
- Subaru select monitor
Inspection
Refer to “ME” section for V-belt inspection. V-belt > INSPECTION V-belt > INSPECTION ...
Basic diagnostic procedure procedure
CAUTION:• The power steering control module continues to operate after the engine stops and calculate the temperature in the control module. Therefore, before starting service of the power steer ...
Other materials:
Installation
CAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.1. Install the rear lock button and the switch - opener rear gate.2. Install the garnish assembly - rear gate. Rear Gate Garnish > INSTALLATIONTightening torque4.5 N·m (0.4 kgf-m, ...
© 2017-2026 Copyright www.sulegacy.com
