Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc c2548 vehicle dynamics control module system

Subaru Legacy BN/BS (2015-2019) Service Manual / Power assisted system (power steering) (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc c2548 vehicle dynamics control module system

DTC DETECTING CONDITION:

When error flag from VDCCM is detected for 2 seconds after the ignition switch is ON.

STEPCHECKYESNO

1.CHECK DTC.

Read the DTC of VDC system using the Subaru Select Monitor.

Is a DTC related to VDC system (sensors) detected-

Perform the diagnosis according to the DTC. List of Diagnostic Trouble Code (DTC)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2548 VEHICLE DYNAMICS CONTROL MODULE SYSTEM

2.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system using the Subaru Select Monitor. Basic Diagnostic Procedure

Is a DTC related to CAN communication detected-

Perform the diagnosis according to the DTC. List of Diagnostic Trouble Code (DTC)

Replace the steering gearbox. Electric Power Steering Gearbox

Dtc c2551 power supply relay
DTC DETECTING CONDITION:• When contact deposit malfunction of power supply relay is detected at initial check.• When power supply voltage failure is detected after the ignition switch is O ...

Dtc c2547 eyesight check sum
DTC DETECTING CONDITION:When check sum error of EyeSight transmission data is detected after the ignition switch is ON.TROUBLE SYMPTOM:EyeSight steering support function does not operate.STEPCHECKYESN ...

Other materials:

Transfer clutch pressure test inspection
1. EXCEPT FOR OUTBACK MODEL1. Lift up the vehicle.2. Remove the rear exhaust pipe from center exhaust pipe.3. Remove the center exhaust cover.4. Set the transmission jack under the transmission.5. Remove the mounting bolt of rear crossmember.6. Lower the rear side of transmission until the transfer ...

© 2017-2026 Copyright www.sulegacy.com