Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc c2547 eyesight check sum

Subaru Legacy BN/BS (2015-2019) Service Manual / Power assisted system (power steering) (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc c2547 eyesight check sum

DTC DETECTING CONDITION:

When check sum error of EyeSight transmission data is detected after the ignition switch is ON.

TROUBLE SYMPTOM:

EyeSight steering support function does not operate.

STEP	CHECK	YES	NO
1.CHECK POOR CONTACT OF CONNECTOR.	Is there poor contact of the stereo camera connector-	Repair the poor contact of connector.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2547 EyeSight CHECK SUM
2.CHECK DTC. Read the DTC for the EyeSight system using the Subaru Select Monitor.	Is DTC of EyeSight system detected-	Perform the diagnosis according to the DTC.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2547 EyeSight CHECK SUM
3.CHECK LAN SYSTEM. Perform the diagnosis for LAN system using the Subaru Select Monitor. Basic Diagnostic Procedure	Is a DTC related to CAN communication detected-	Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2547 EyeSight CHECK SUM
4.CHECK POWER STEERING CONTROL MODULE. 1) Connect all connectors. 2) Perform the Clear Memory Mode. Clear Memory Mode 3) Perform the Inspection Mode. Inspection Mode 4) Read the DTC.	Is DTC C2547 detected-	Replace the steering gearbox. Electric Power Steering Gearbox	It results from a temporary noise interference.

Dtc c2548 vehicle dynamics control module system

DTC DETECTING CONDITION:When error flag from VDCCM is detected for 2 seconds after the ignition switch is ON.STEPCHECKYESNO1.CHECK DTC.Read the DTC of VDC system using the Subaru Select Monitor.Is a D ...

Dtc c2546 eyesight value

DTC DETECTING CONDITION:When the steering support indication value from stereo camera is out of range after the ignition switch is ON.TROUBLE SYMPTOM:EyeSight steering support function does not operat ...

Other materials:

Inspection
Wash all the disassembled parts clean, and examine them for wear, damage and other defects. Repair or replace the defective parts as necessary.1. Hypoid driven gear and drive pinion• If there is evidently an abnormal tooth contact, find out the cause and adjust until the teeth contact correctl ...