Subaru Legacy BN/BS (2015-2019) Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
Subaru Legacy BN/BS (2015-2019) Service Manual / Power assisted system (power steering) (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u1469 invalid data received from autostart stop control module
- Dtc u0100 lost communication with ecm/pcm "a"
- Dtc u1433 invalid data received from eyesight
- Dtc u1235 lost communication with eyesight
- Dtc u1120 lost communication with autostart stop control module
- Dtc u0073 control module communication bus off
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0401 invalid data received from ecm/pcm "a"
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc c2551 power supply relay
- Dtc c2548 vehicle dynamics control module system
- Dtc c2547 eyesight check sum
- Dtc c2546 eyesight value
- Dtc c2545 eyesight system
- Dtc c2544 auto start stop system
- Dtc c2543 error passive
- Dtc c2541 vehicle dynamics control module vehicle speed sensor
- Dtc c2533 control module board temperature sensor
- Dtc c2532 control module peripheral circuit
- Dtc c2531 control module cpu
- Dtc c2522 resolver sensor
- Dtc c2521 motor malfunction
- Dtc c2514 torque sensor power supply
- Dtc c2513 torque sensor much tolerance
- Dtc c2512 torque sensor sub
- Dtc c2511 torque sensor main
- Dtc u0126 lost communication with steering angle sensor module
- Dtc u0122 lost communication with vehicle dynamics control module
Electrical specification
NOTE:The terminal numbers of the power steering control module connectors are as indicated in the figure.ContentConnector No.Terminal No.Input/output signalMeasured value and measuring conditionsPower ...
Dtc u1469 invalid data received from autostart stop control module
NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure ...
Other materials:
Installation
1. RADIO ANTENNA AMPLIFIER1. Install the amplifier assembly - antenna.Tightening torque:12±3 N·m (1.2±0.3 kgf-m, 8.9±2.2 ft-lb)2. Install the trim panel - rear pillar UPR LH. (Sedan model)3. Install the trim panel - rear gate UPR. (OUTBACK model)4. Connect the ground terminal to battery se ...
© 2017-2026 Copyright www.sulegacy.com
