Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc c2531 control module cpu

Subaru Legacy BN/BS (2015-2019) Service Manual / Power assisted system (power steering) (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc c2531 control module cpu

DTC DETECTING CONDITION:

When microcomputer malfunction is detected after the ignition switch is ON.

TROUBLE SYMPTOM:

• The steering wheel operation feels heavy.

• STEERING warning light illuminates.

NOTE:

When this code is displayed, replace the steering gearbox with a new part. Electric Power Steering Gearbox

Dtc c2532 control module peripheral circuit

DTC DETECTING CONDITION:• When torque sensor peripheral circuit malfunction inside the power steering control module is detected after assist starts with 500 rpm engine speed reception.• W ...

Dtc c2522 resolver sensor

DTC DETECTING CONDITION:When resolver signal output voltage failure is detected after assist starts with 500 rpm engine speed reception.TROUBLE SYMPTOM:• The steering wheel operation feels heavy ...

Other materials:

Removal
CAUTION:Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Disconnect the harness connector from the turbine speed sensor.4. ...