Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc p0560 system voltage

Subaru Legacy BN/BS (2015-2019) Service Manual / Engine (diagnostics)(h4do) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p0560 system voltage

DTC DETECTING CONDITION:

Immediately at fault recognition

CAUTION:

After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.

WIRING DIAGRAM:

• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON START) Engine Electrical System > WIRING DIAGRAM

• Engine Electrical System ENGINE TYPE FB (WITH PUSH BUTTON START) Engine Electrical System > WIRING DIAGRAM

STEP	CHECK	YES	NO
1.CHECK INPUT SIGNAL OF ECM. 1) Turn the ignition switch to OFF. 2) Measure the voltage between ECM connector and chassis ground. Connector & terminal (B134) No. 27 (+) — Chassis ground (−):	Is the voltage 10 V or more-	Repair the poor contact of ECM connector.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0560 SYSTEM VOLTAGE
2.CHECK HARNESS BETWEEN ECM AND MAIN FUSE BOX CONNECTOR. 1) Disconnect the connector from ECM. 2) Measure the resistance between ECM connector and chassis ground. Connector & terminal (B134) No. 27 — Chassis ground:	Is the resistance 1 M- or more-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0560 SYSTEM VOLTAGE	Repair the short circuit to ground in harness between ECM connector and battery terminal.
3.CHECK FUSE NO. 12 (MAIN FUSE BOX).	Is the fuse blown out-	Replace the fuse.	Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit in harness between ECM connector and battery • Poor contact of ECM connector • Poor contact of battery terminal

1. OUTLINE OF DIAGNOSIS

Detect the open/short circuit of back-up power supply circuit.

Judge as NG when the backup power voltage is low.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
Battery voltage	≥ 10.9 V

3. GENERAL DRIVING CYCLE

Always perform the diagnosis continuously.

4. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
Voltage of back-up power supply	≤ 3.5 V

Time Needed for Diagnosis: 2500 ms

Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.

Dtc u0122 lost communication with vehicle dynamics control module

NOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure1. OUTLINE OF DIAGNOSISNOTE:For the detection standard, refer to DTC U0101. Diagnostic Procedure with Diagnostic Tr ...

Dtc p0125 insufficient coolant temperature for closed loop fuel control

DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:Engine does not return to idle.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...

Other materials:

Dtc c1362 normal closing valve 2
DTC DETECTING CONDITION:A fault is detected if electrical malfunction judgment is generated for VDCH/U solenoid valve.TROUBLE SYMPTOM:• ABS does not operate.• EBD does not operate.• VDC does not operate.• Hill hold does not function.• EyeSight does not operate. (Models ...