Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc u1235 lost communication with eyesight

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc u1235 lost communication with eyesight

NOTE:

Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure

1. OUTLINE OF DIAGNOSIS

• Detect malfunction of CAN communication.

• Judge as NG when CAN communication failure occurs with the stereo camera.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
Turbine shaft speed	> 0 rpm
or
D range switch	ON

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
CAN data from stereo camera	Lost

Time Needed for Diagnosis: 2 seconds

Dtc p0717 input/turbine shaft speed sensor "a" circuit no signal

DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Standing start problems• Shock occurs when engaging the lockup clutch.• Shock occurs when selecting shift po ...

Dtc u0073 control module communication bus off

NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure1. OUTLINE OF DIAGNOSIS (ENGINE TYPE FB)• Detect malfunction of CAN communication.• ...

Other materials:

Operation
NOTE The rear gate will remain unlocked even after closing it. Always lock the rear gate when leaving the vehicle. If you cannot open/close the rear gate by performing the operation described here, a short electronic chirp will sound three times (beep, beep, beep). B ...