Subaru Legacy BN/BS (2015-2019) Service Manual: Forced drive
CAUTION: After a forced operation, make sure to perform an initialize operation. Sunroof Control System > OPERATION If the lid assembly - sunroof does not operate or the motor assembly is not supplied with power, remove the motor assembly to move the lid assembly - sunroof manually. 1. Remove the overhead console. (Models without EyeSight) Spot Map Light > REMOVAL 2. Remove the stereo camera cover assembly. (Models with EyeSight) Stereo Camera > REMOVAL 3. Remove the connector and bolt to remove the motor assembly. 4. Move the lid assembly - sunroof by hand. 5. Install the connector and bolt. 6. Install the overhead console. (Models without EyeSight) Spot Map Light > INSTALLATION 7. Install the stereo camera cover assembly. (Models with EyeSight) Stereo Camera > INSTALLATION |
Glass lid
...
Adjustment
1. Adjust the height of the lid assembly - sunroof and the roof panel.2. Loosen the lid assembly - sunroof mounting bolts, and then adjust the height by moving the lid assembly - sunroof side.Lid asse ...
Other materials:
Dtc b16eb side airbag sensor lh initialization error
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Side airbag sensor LH initialization errorWIRING DIAGRAM:NOTE:For the coupling connector, refer to “WIRING SYSTEM”.Airbag system Airbag System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK POOR CONTACT OF CONNECT ...
