Subaru Legacy BN/BS (2015-2019) Service Manual: Front drive shaft

Installation

1. Install the housing assembly - front axle to the strut assembly.(1) Align alignment marks on the camber adjusting bolt and strut.(2) While holding the bolt head of adjusting bolt, tighten the nut.T ...

Removal

1. Lift up the vehicle, and then remove the front wheels.2. Remove the nut - axle.CAUTION:Do not loosen the nut - axle while the front axle is loaded. Doing so may damage the hub unit COMPL.(1) Lift t ...

Other materials:

Dtc p013a o2 sensor slow response - rich to lean bank 1 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...