Subaru Legacy BN/BS (2015-2019) Service Manual: Front fender

Installation

1. FRONT DOOR PANEL1. Put a wooden block and the like on a jack and place the panel assembly - front door on it.2. Adjust the height by the jack, and temporarily install the panel assembly - front doo ...

Removal

1. FENDER PANEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the bumper face - front. Front Bumper > REMOVAL3. Remove the light assembly - head. Headlight Assembly > REMOVAL4 ...

Other materials:

Dtc p0057 a/f / o2 heater control circuit low bank 2 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...