Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
Repair or replace any faulty hoses, pipes, and clamps found in the inspection below. • Check for CVTF leaks in joints at the transmission, radiator, CVTF cooler (air cool), pipes, and hoses. • Check the clamp for deformation. • Lightly bend the hose and check for cracks in the surface or other damages. • Pinch the hose with your fingers and check for poor elasticity. Also check for poor elasticity in the parts where the clamp was installed by pressing with your fingernail. • Check for peeling, cracks, and deformation at the tip of the hose. |
Removal
CAUTION:• Immediately after the vehicle has been running or after idling for a long time, the CVTF will be hot. Be careful not to burn yourself.• If the CVTF is spilt over exhaust pipe, wi ...
Installation
CAUTION:When installing the CVTF cooler pipe assembly on vehicle side, be careful not to bend the A/C pipe.1. Install the CVTF cooler pipe assembly to vehicle.Tightening torque:7.5 N·m (0.8 kgf ...
Other materials:
Dtc p0037 a/f / o2 heater control circuit low bank 1 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...
